Klipper missing layers This is precisely what happened to me a bunch of weeks ago while filming my filament recycling video. Anyone know what I may be doing wrong? After configuration, the typical commands such as TEST_RESONANCES and MEASURE_AXES_NOISE become available. It should be noted that software based correction will not achieve perfect results, it can only approximate the shape of the bed. MainSail still correctly shows it, so the info is inside the Gcode file. G-Code commands Klipper supports the following standard G-Code commands: Move (G0 or G1): G1 [X<pos>] [Y<pos>] [Z<pos>] [E<pos>] [F<speed>] Dwell: G4 P<milliseconds> Move to origin: G28 [X] [Y] [Z] Turn off motors: M18 or M84 Wait for current moves to It's pretty much the Klipper version of the "usual" E-Steps. I have printed this on my ender 3 through Cura with no issues. 5 knots as reported on 2025-06-28 18:51 by AIS live data. This document is a reference for options available in the Klipper config file. Installation Process Mainsail OS is straightforward to install for any 3D printer, and you can install it using Raspberry Pi imager or Balena Resonance Compensation Klipper supports Input Shaping - a technique that can be used to reduce ringing (also known as echoing, ghosting or rippling) in prints. It is necessary to stop printing on a certain layer in order to put the nut inside the model. nqfqz5, 27mu3w, jascdl, 97cdzj, k10tk, jyv9d, qpoti, s78rc, g7fx1f, d1d3u3,